Peumatic Grouting pump is designed for strain and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the unfastened rock mass. The most grain measurement can’t exceed zero.2 mm.
Grouting pump operation and upkeep is simple, safe and reliable. This pump is used in mines working beneath tough situations as a outcome of it’s reliable and explosion-proof.
Basic Pneumatic Grouting pump embody: An air inlet, the pneumatic cylinder, mounting base body and stand, pressure gauge, pumping cylinder, outlet with fast launch coupling and wheels.
How it works
Pneumatic strain within the air cylinder exerts a excessive pressure on the grout combination which leads to ejection of grout with a excessive pressure and velocity. The valves of the air cylinder within the pump operate automatically to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to complete the pumping cycle.
Pneumatic grout pump can be pushed even without Electrical energy provide in remote areas through the use of engine pushed compressor.
เกจวัดแรงดันแก๊สlpgรถยนต์ is majorly used in development and mining trade for injecting materials into broad and medium dimension hole in beams, columns ,basement partitions and flooring, raise shaft concrete wall fill-up and so on. In mining trade it is used to fill up cement solution the place there’s a hole exists between construction and rock and for soil stabilization.
Detachable design tends to straightforward maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is widely used in tunnels, coal mine, bridges and dams, building foundation, and other underground tasks, and inflammable, explosive websites and other unhealthy surroundings.
It has utility in chemical trade also to pump out chemical slurries.
The pump is electrical energy free so, can be utilized at any site condition whether or not it’s rural or urban.
Mining Pneumatic Grouting pump has a larger discharge slurry adjustment vary. Generally the final amount of the grouting quantity is 8 or10 occasions of the quantity to start with. And the final grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and move may be adjusted according to the requirements of grouting,(The circulate of grouting pump is 0-100L/min, stress of discharge is 0-10MPa).besides, This Pneumatic high-pressure grouting pump can be utilized for grouting single or double fluid.
High-pressure grouting pump is principally used for highways, railways, water and electrical energy, construction, mining etc. ground/underground building.
Benefits
Mining Pneumatic Grouting pump has the advantages of low vitality consumption, small vibration, low noise, small dimension, high efficiency, reliable efficiency, pressure and circulate management, lengthy life and so on. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can additionally be Light weight and with a wheelie design it can be carried easily. It is designed for straightforward operation and low maintenance. Last but not least its spare components are simply out there.
Share